Fairbanks VSX SERIES TRUCK SCALE - Manual (Page 16)

Section 2: Installation
04/12 16 51173 Rev. 8
Place Main Beams
1. Move the beams close to their approximate locations. All girders with j-box
mounting bars should be on the same side, nearest the scale house.
2. To identify your beams, see Figure 2-2. If there are several interior beams,
consult the certified print for the correct placement order.
Figure 2-2
Assemble the Left Hand Base Module
1. Set the left hand base girders first (both J-Box and Plain sides).
a. To begin, set girders on shoring timbers. The beams and modules should
remain on shoring timbers until the all modules are assembled and all
module connection hardware is fully tightened. DO NOT use locating
tools at this stage.
b. Center the left hand end base girders on the load cell centerline and put
the end of the beams with the check block against the end wall.