Fairbanks 4000 SERIES Pallet Weigh - Manual (Page 18)

05/12 18 51285 Rev. 1
Section 5: Service and Maintenance
5.1. CLEANING
•
Wipe the scale assembly with a damp cloth using water only.
─ Do not spray cleaners onto scale indicator.
─ Do not wash-down with a pressure cleaner or water hose.
─ Do not allow water or liquids to drip onto scale indicator.
5.2. ERROR MESSAGES
Error Description Solution
HELP 1 Weight exceeds scale capacity Remove weight from scale.
HELP 2 Scale is Overloaded. Remove weight from scale. If no
weight is on scale contact
Fairbanks Service.
HELP 3 or 7 Load cell signal is too low or too
high. Contact Fairbanks Service.
HELP 4 Out of Zero range. Zero calibration required.
Weight is unstable. Stabilize the weight on the scale.
Excessive vibration on floor.
LobA Battery voltage is low. Replace 4-AA batteries.