Fairbanks 4100 SERIES Pallet Weigh Plus - Manual (Page 22)

Section 4: Operation
10/13 22 51287 Rev. 2
10. If the key is pressed during this period, the total is reset but not printed
out.
11. If no key is pressed during this period, the subtotal stays in memory and the
system returns to the weighing mode after 60 seconds.
4.4.10. CHANGE UNITS
The system is set to start up in lb. or in kg. However you may, at any time in the
weighing mode, change to the secondary unit (lb/kg or kg/lb).
1. Press the key for 1 second.
2. The display will show the current weight in the new units for 5 seconds and
then automatically change back to the startup units.
The same key is used to change from the piece counting mode back to the weighing
mode.
(See 6.4.7.)
NOTE:
It is not possible to use any of the scale functions when the display has been
changed to the secondary unit. If any key is pressed the indicator will display ERR99
and return to normal weighing mode.
4.4.11. SETTING TIME AND DATE (Optional)
If the Pallet Weigh Plus system has been equipped with a printer, and an option
board, the date and time can be printed together with the weight information.
1. Press the key for 6 seconds.
2. The display will show “ho_00” or the previous hour time setting
3. The right digit flashing.
4. To accept the old value press the key
OR