Fairbanks 4100 SERIES Pallet Weigh Plus - Manual (Page 17)

Section 4: Operation
10/13 17 51287 Rev. 2
4.4.4. Manual Tare Entry
A tare weight can be entered at any moment, either in a loaded or unloaded
condition. For a higher accuracy, a tare weight can be entered with a smaller
graduation step, independent of the applied load and the active graduation of the
indicator.
Note:
The scale must be at a zero condition to enter a manual tare.
1. Pressing the key for three (3) seconds.
2. The display shows the current tare value.
3. The digit on the right hand side of the display will begin blinking.
4. Press the key if the tare is correct.
OR
5. Pressing the key for three (3) seconds.
6. The display shows the current tare value.
7. The digit on the right hand side of the display will begin blinking.
8. Pressing the key will scroll the digit numeric value down or press the
key to increase the numeric value.
9. Press the key to change to the next digit.
10. Repeat this procedure until the required tare value is displayed.
11. Press the key to activate the tare weight.
12. The tare weight is activated.
13. The “NET” pointer lights up.
14. Lift the load
15. When the system is loaded, the NET weight appears in the display