Important precautions, Troubleshooting, Fairbanks service department – Fairbanks FB3000 Inbound/Outbound Program Operators Manual User Manual
Page 37
09/07
37
51149 Rev. 1
Section 5: Service & Maintenance
IMPORTANT PRECAUTIONS
Before handling the FB3000 boards or other system components, a service
technician must always use PSD Precautions.
•
Electrostatic Discharge (ESD) can easily damage the
FB3000 board assemblies.
•
Remove the anti-static packing only when the parts are
ready for installation.
•
Handle the boards by their edges, and avoid touching their
components.
TROUBLESHOOTING
Error Condition(s)
Solution(s)
• Check that scale is empty.
• If Scale is empty, Call for
Service.
• Load Cell(s) bad.
• A large amount of weight is zeroed.
• This
is
normal.
• Press
OK
and continue weighing.
• Possible load cell damage.
• Call for Service.
• Load Cell Failure(s)
• Flashing and displays “
- - - -
“
• Possible load cell damage.
• Call for Service.
• Access
the
Load Cell Diagnostics Menu
to verify the
load cell status.
• Count stability or change of counts.
• Contact the local service for further trouble-shooting.
SC Cells Found None
• Possible damaged load cell cable.
• Load
cell
shortened.
• Defective Pit Power Supply.
• Defective Smart Sectional Controller(s).
• Defective Analog Assembly.
• Call for Service.
Displays “
- - - -
“ ~ lb GROSS
• Communication error to load Cells.
• Call for Service.
NOTE:
Call the
Fairbanks Service Department
for all unit updates, repairs,
and further advice on the FB3000 In/Out Program.