Fairbanks BPP2000 Portable Platform Scale - Manual (Page 13)

Section 2: Installation
Base Assembly, Continued
5. Insert a cotter pin ( #17 ) through the
Axle Rod.
• Using needle nose pliers, bend
back both haves of the cotter pin
to secure the wheel assembly.
6. Repeat steps two through four (2-4)
for the second axle.
7. Center the axles in the base, and then
insert the four locking screws ( #15 )
into each of the tapped holes in the
bottom of the base.
• Located directly under the axle
holes
8. Tighten the locking screws, and then
secure the Lock Nuts ( #14 ).
9. Turn the platform over so it sets on
the wheels.
After inserting the four Cotter Pins, center the
axles, tighten the Locking Screws, and then
secure the Lock Nuts.
03/13 13 50699 Rev. 4