Fairbanks 27135 TeleWeigh with Bluetooth - Manual (Page 12)

Section 4: Operation
08/07 12 51166 Revision 1
Weighing with Bluetooth
®
Communications
1. On the bottom-side of the scale, move the
switch to the appropriate setting.
▪ BT ( Bluetooth ®
Communications ) is used for
communicating the weighment from
the scale to an external wireless
Remote Bluetooth device.
2. Once the switch is selected, place the
scale on a flat surface where it will be used.
3. Stand on the scale. This will activate the scale.
4. The scale will beep once to indicate it has started a measurement cycle and
start displaying the weight. The scale will establish communications with the
remote Bluetooth
®
device.
5. The scale will indicate a Bluetooth
®
connection has been established by
turning on the CONNECTED indicator on the display.
6. Once the weight is stable, the scale will beep twice, indicating the weight has
been captured and the display will show the captured weight.
7. Step off the scale. The displayed weight is held on the display for at least ten
(10) seconds.
8. The captured weight is sent to the remote Bluetooth
®
device. If the Remote
device does not confirm the weight has been received the scale will retry
several times to resend the weight. If the weight is not accepted the scale will
beep three times and display
to indicate the weight was not sent. The
unsent weight is stored internally to be resent during the next measurement
cycle. The scale can store up to 10 measurements internally.
9. After the communication is complete, the scale will briefly try to re-zero itself
for the next weighment, provided there is less than ten (10) pounds on scale.
10. The scale will turn off and the weighing process is complete.