Fairbanks Series III Bench Scales - Manual (Page 6)

50778 6 07/10 -- Rev. 6
A. General Service Policy
It is the customer/operator's responsibility to ensure the equipment provided by Fairbanks is
operated within the parameters of the equipment's specifications and protected from
accidental or malicious damage. Other than the procedures authorized in this manual, no
service, repair, or adjustments may be performed by unauthorized/untrained service
personnel. Any unauthorized repairs will void any verbal, implied, or written warranties.
B. Overview
1. These instructions apply to the instrument and its specific installation procedures.
2. All electronic and mechanical calibrations and or adjustments required to make this
equipment perform to accuracy and operational specifications are considered to be
part of the installation, and are included in the installation charge. Only those charges
which are incurred as a result of the equipment's inability to be adjusted or calibrated
to performance specifications may be considered warranty.
3. Absolutely no physical, electrical or program modifications are to be made to this
equipment. Electrical connections other than those specified may not be performed,
and physical alterations (holes, etc.) are not allowed.
4. Before the installation is considered complete, the equipment is to be programmed to
meet or exceed any applicable weights and measures requirements, if applicable.
The installing technician is responsible to make certain customer personnel are fully
trained and familiar with the capabilities and limitations of the equipment. Be
prepared to recommend the arrangement of components which will provide the most
efficient layout, utilizing the equipment to the best possible advantage. The warranty
policy must be explained and reviewed with the customer.
C. Unpacking
1. Check that all components are on hand, and agree with the equipment order.
2. Remove all components from their packing material, checking to make certain that all
parts are accounted for and no parts are damaged. Advise the shipper immediately,
if damage has occurred. Order any parts necessary to replace those which have
been damaged. Keep the shipping container and packing material for warranty
returns, if necessary. Check the packing list.
3. The shipping carton should contain the following: Manual, Instrument, Platform,
Pillar, and AC Adapter.
Section 2: Installation