Fairbanks Series III Bench Scales - Manual (Page 12)

50778 12 07/10 -- Rev. 6
B. Operation
1. Taring
All models have taring capabilities up to their total weight capacity. To weigh a
sample in its container with the display showing the weight of the sample, use the
following tare procedure.
a. Place sample container on pan and then press the
b. Now place sample in its container.
c. When the balance is stable, the display shows the weight of the sample.
2. Counting Function
a. Counting feature must be enabled. It comes disabled from the factory.
b. Count the desired number of sample pieces (10, 20, 50, 100 or 200 total pieces )
key to display total count numbers of 10, 20, 50 or 100.
This number will cycle; press # of parts key again to select sample size once
it is displayed. The arrow at the bottom of the display will point to PCS.
d. You are now ready to perform parts counting of those specific pieces.
key for the total weight.
Repeat steps b through d for each type of piece to be counted.
key.
c. Press
Press the