Fairbanks 5000 Series Bench Scale Platforms - Manual (Page 9)

07/13 9 51245 Rev. 3
Section 4: Parts Replacement
Load cell replacement
Tools required:
•
Open-end wrench
•
Side cutter
•
Torque wrench
Procedure:
1. Disconnect the instrument from the power supply.
2. Place the platform upright without the cover.
3. Remove the screws holding the load cell and spacer in place.
4. Remove the load cell and cable, and note the cell and cable placement!
5. Install the new load cell and the spacer(s).
6. Tighten the load cell mounting screws to 8 (± 2) INCH/LBS of torque only.
7. Route the load cell cable exactly as the original cable and plug in the connector.
8. Calibrate the instrument.