Asus DSEB-DG/SAS - Manual (Page 65)

ASUS DSEB-DG Series -1
3.1 Starting up for the first time
1. After making all the connections, replace the system case cover.
2. Be sure that all switches are off.
3. Connect the power cord to the power connector at the back of the system
chassis.
4. Connect the power cord to a power outlet that is equipped with a surge
protector.
5. Turn on the devices in the following order:
a. Monitor
b. System power
6. After applying power, the system power LED on the system front panel case
lights up. For systems withATX power supplies, the system LED lights up
when you press the ATX power button. If your monitor complies with “green”
standards or if it has a “power standby” feature, the monitor LED may light up
or switch between orange and green after the system LED turns on.
The system then runs the power-on self tests or POST. While the tests are
running, the BIOS beeps (see BIOS beep codes table below) or additional
messages appear on the screen. If you do not see anything within 30
seconds from the time you turned on the power, the system may have failed a
power-on test. Check the jumper settings and connections or call your retailer
for assistance.
Phoenix BIOS beep codes
Beep Description Error
Endless beep Memory module missing
One continuous beep followed by VGA controller failure
two short beeps
Two short beeps
PCI resource assignment error
7. At power on, hold down the key to enter the BIOS Setup. Follow the
instructions in Chapter 4.