Asus DSEB-DG/SAS - Manual (Page 50)

2-30 Chapter 2: Hardware information
5. Intel ® 6321ESB SATA port S/W RAID setting (3-pin RAID_SEL1)
(DSEB-DG model only)
This jumper allows you to select the Serial ATA RAID configuration utility to
use when you create disk arrays. Both utilities are supported by the
Intel ® 6321ESB. Place the jumper caps on pins 1-2 if you want to use the LSI
MegaRAID Serial ATA RAID utility (default); otherwise, place the jumper caps
on pins 2-3 to use the Intel ® Matrix Storage Manager (IMSM).
®
DSEB-DG Series RAID setting
RAID_SEL1
1
2 2
3
Intel LSI
(Default)
4. Fan control setting (3-pin CPUFAN_SET1, CHAFAN_SET1)
These jumpers allow you to switch for fan pin selection. The CPUFAN_SET1
jumper is for the CPU fans control and CHAFAN_SET1 is for the other fans
control including front fans, rear fans and FB-DIMM fans. Set to pins 1-2 for
4-pin fans or pins 2-3 for 3-pin fans.
®
DSEB-DG Series FAN setting
FAN_SET1
FAN_SET2
1 2 2 3
Balanced
(Default)
DC FAN
• If you use a 4-pin fan but set the jumper to pin 2-3, the fan you installed
may not work.
• If you use a 3-pin fan but set the jumper for a 4-pin fan, the fan controll will
not work and the fan you installed will always run at full speed.
(CPU Fan)
(Other Fans)