FIREPOWER 5208 User Manual

Page 2

Model SK-5208 Fire Control/Communicator Installation and Operation Manual

5-2

P/N 151204

5.2 On-board Touchpad and SK-5235 Operation

Basic operations for the on-board annunciator (touchpad) and SK-5235 are described in Table
5-1. If you are using an annunciator key or the Flex Door option, you are not required to enter
a code for operator level functions.
If no keys are pressed for 4 minutes while in program mode, the system will time out and
resume normal operation.

* Code = any valid operator or installer code.

Table 5-1: Basic Panel Operations Using the On-Board Annunciator and the SK-5235

How To

Do This

Comments

Press

Display

Message

Press*

Test the system

System Test
Enter Code

Enter Code

System performs a display lamp test, a
communication test, and displays the firmware
number and revision. See 5.2.1 for an example.

Reset Alarms

Reset Alarm
Enter Code

Enter Code

Resets system.

Clear History

Clear History
Enter Code

Enter Installer
Code

Clears event history of all events.

Reset the Dialer

Reset Dialer
Enter Code

Enter Code

Resets the dialer and aborts the call to central
station.

Call Computer to Up/
Download

Call Computer
Enter Code

Enter Installer
Code

Will dial the programmed phone number for the
computer to initiate an up or download.

Display History
Events

History Events
Enter Code

Enter Code

Displays panel history, including alarms,
supervisories, troubles, reports, time and date
changes, etc.

Show Status

Show Status
Enter Code

Enter Code

View existing system status. List Alarms first,
supervisories and then troubles.

Silence Troubles or
Alarms

Silence
Enter Code

Enter Code

Set the Date

Set Date
Enter Code

Enter Code

Enter 8 digits for the date. For example, to set

the date 08/31/1999 enter 08311999. Press

to clear incorrect entries.

Set the Time

Set Time
Enter Code

Enter Code

Enter the time in 24 hour increments. For
example, 1:00 pm = 13:00.

Disable/Enable a
Zone

Zone # +

Disable Zone
Enter Code

Enter Code

Repeat the process to enable the zone.

Disable/Enable NAC

NAC #

Disable NAC
Enter Code

Enter Code

Repeat the process to enable the NAC.

Conduct a Fire Drill

Fire Drill
Enter Code

Enter Code

To End the Fire Drill press

then code.

Reset Detectors

Rst Smk Pwr
Enter Code

Enter Code

Resets all smoke detector power.

Walk Test the System

Walk Test
Enter Code

Enter Code

To End the Walk Test press

Menu of Options

Press

scroll through list.

To exit press

or wait 15 seconds.