FEC AFC1150 - Manual (Page 9)

)(& ,QF
6.5 In Bypass/Normal Switch
Fig. 6.5
w When this switch is set to IN BYPASS, the LED on the switch will be lit and the controller
will ignore all I/O Terminal and manual button signals.
w This switch should be set to Normal prior to operating this system.
w The READY output will be inactive and BYPASS output will be active while the switch is set
to IN BYPASS.
w The Busy/Abnormal LED, the three Code LED's, and the Abnormal output signal will be
cleared when the switch is set to IN BYPASS.
w All tool rotation will stop if the switch is moved to IN BYPASS while running.
CHAPTER 6: PRE-SETS AND OPERATION
Page 6 - 9