FEC AFC1150 - Manual (Page 8)

)(& ,QF
6.4 Timed Speed Change Set-Up
w Slow Start Time switches are used to
select the length of time the equipment
will operate in slow speed prior to
accelerating to high speed when
operating in speed change mode.
w Verify power is off, or bypass mode has
been selected and In Bypass switch is
lit, prior to changing the setting of the
Slow Start Time switches.
w Do not change this set-up while the
tool is running because it may result in
operation errors or accidents.
w Refer to the following table for the time
values of each switch.
Fig. 6.4
4 seconds 1
3 seconds 2
Actual time may vary slightly. 2 seconds 3
Times listed in this table are approximate. 1 second 4
SLOW SPEED SWITCH
TIME IN SELECTED
NOTE: Select only one time switch. Times are not cumulative, and the maximum
approximate time available prior to acceleration is 4 seconds.
CHAPTER 6: PRE-SETS AND OPERATION
Page 6 - 8