FEC AFC1500 - Manual (Page 42)

AFC1500 Multi-2 Unit Hardware Manual (Rev2.1)
PAGE 5 - 42
Chapter 5: Control Interfaces
5.9 CC-Link
®
Interface (Version 2)
FEC integrates the CC-Link board (Version 2 setting) manufactured by HMS Fieldbus Systems AB into
the Multi-2 Unit
’s modular I/O board when CC-link must send both I/O and Message Data. For further
technical information on the CC-Link (Version 2) interface go to the HMS website. ( www.hms.se )
NOTE: The FEC CC-Link (V2)
module is configured as a “Remote Device Station” when setting up the
parameters in the PLC program.
For detailed information on the Mitsubishi CC-Link Network, see the Mitsubishi User Manual # 13J872
Control & Communication - Link System Master / Local Module.
Item Description
1 Application Connector
2 CC-Link Connector
3 Baud Rate Setting Switch
4 Station Number Setting Switches (2)
5 Status LEDs (4)
6 Watchdog LED
Red - (flashing @ 2Hz) - ASIC and FLASH ROM check fault.
Green (flashing @ 2Hz) - module not initialized.
Green (flashing @ 1Hz) - module initialized and running OK.
Red (flashing @ 1Hz) - RAM check fault.
Red (flashing @ 4Hz) - DPRAM check fault.
DB9 Connector
DB9 Connector (male)
1
5
6
9
5
1
9
6
RBC BA
RBDA/ERR
(female)
Daughter board
3
2
5
1
6
4
- Represents switch position