Emtech Electronics BLU-CIF2 - Manual (Page 2)

2
BLU-CIF RJ-45 CONNECTIONS
TOP ROW BLU-CP1 BLU-CC1A BLU-SV2 BLU-IR2
BTTM ROW BLU-CS/SV1 BLU-CC1B BLU-IR1 BLU-IR3
TOP ROW BLU-IR4 BLU-CP2 BLU-SV4 BLU-
CC2A/SV5
BTTM ROW BLU-IR5 BLU-CS2/SV3 BLU-SV7 BLU-
CC2B/SV6
IMPORTANT: If you use the RJ-45 blocks for connecting the BLU-
CC, BLU-CP, BLU-CS, BLU-IR and BLU-SV(8) modules, then do not
use any of the 3.5mm euro-style connectors for these accessories. If you
are using the BLU-IR Infrared Sensors for combining audio in overflow
areas, then you have a choice to use either the RJ-45 connections in their
blocks or the 3.5mm euro-style connectors. Wiring the BLU-IR Infrared
Sensors into the 3.5mm connectors will be covered later on in this
document.
A legend for the BLU-CIF2 RJ-45 connections has been silkscreened on the
Interface Board next to the corresponding block of connectors.
BLU-CIF2 3.5mm Euro-block Wiring Instructions
The 3.5mm euro-block connectors have been provided for easy installation
of the BSS Audio equipment into older buildings with existing analog
wiring. Connectors for the BLU-CC, BLU-CP, BLU-CS and BLU-SV have
On the left side of the
BLU-CIF2 Interface
Board are two 2 X 4
blocks of RJ-45
connectors for
terminating the BLU
products via Cat5e
wiring. The BLU
products connect in
this order (left to
right), starting with
Block 1:
BLOCK 1
BLOCK 2
BLOCK 1 BLOCK 2