Emtech Electronics BLU-SV8T - Manual

BLU-SV8T Source Selector/Volume Control
BLU-SV8 Wiring Instructions
IMPORTANT: CAT5e wiring for the RJ-45 connector needs to be
crimped to TIA/EIA 568B Standards (see below) on both ends of the cable.
You must crimp and test the wiring with an approved CAT5 568A/B
tester before connecting any cable between the BLU-SV8 and either a
BLU-CIF or BLU-CIF2 Interface unit. Failure to crimp wiring to the
correct standard could possibly lead to component damage.
EIA/TIA568B
1. White-Orange 5. White-Blue
2. Orange 6. Green
3. White-Green 7. White-Brown
4. Blue 8. Brown
The BLU-SV8T is a
source selector/volume
control for BSS Audio
London Series Digital
Signal Processors. It is
built on a dual gang
panel for mounting in a
dual gang electrical box.
The front side of the
control has 8 lighted
momentary pushbutton
switches for selecting
audio, and a pot for
adjusting the volume of
the audio signal. On the backside of the control is a single RJ-45 Cat5e
jack for connecting the BLU-SV8 to the DSP via the BLU-CIF or BLU-
CIF2 SV ports. The BLU-SV8T installs in the tech room.