beautypg.com

Emtech Electronics BLU-CC User Manual

Blu-cc2 remote control, Important

background image

BLU-CC2 Remote Control


BLU-CC Wiring Instructions

IMPORTANT:

CAT5e wiring for the RJ-45 connector needs to be

crimped to TIA/EIA 568B Standards (see below) on both ends of the cable.
You must crimp and test the wiring with an approved CAT5 568A/B
tester before connecting any cable between the BLU-CC and either a
BLU-CIF or BLU-IF Interface unit.
Failure to crimp wiring to the correct
standard could possibly lead to component damage.

EIA/TIA568B

1. White-Orange

2. Orange

3. White-Green

4. Blue

5. White-Blue

6. Green

7. White-Brown

8. Brown

The BLU-CC2 is a 3-input (3-mic or
2-mic & 1-transformer balanced stereo
to mono line input) remote control for
BSS Audio London Series Digital
Signal Processors
. It is housed in a 3-
gang wall mountable box with a
latching door. On the backside of the
control, there is a pair of RJ-45 Cat5e
connectors for connecting the BLU-
CC2 to the DSP, and a 3-pin Euro-
block for the audio signal from either
Mic 3 or the Aux Inputs (RCA or
3.5mm) to the DSP.