Teledyne PEM-9002 - Digital flue gas analyzer - Manual (Page 18)

6.2 Calibration Menu
Autozero 60 sec
DO NOT PLACE
PROBE
Batt:
Battery symbols:
empty full
Note: Do not place probe - Leave in ambient air
until the unit is finished with the calibration phase.
Note: Any errors that occur during calibration are
displayed on the information line.
Possible Error Messages:
Low Batt
Batt empty
T-Room Sensor ?
T-Gas Sensor ?
O2 Sensor defect
O2 Sens. Service
CO - Sensor ?
CO - Sensor defect
CO - val. overflow
NO
NO - Sensor defect
NO - val. Overflow
- Sensor ?
13