Teledyne 3300TB - Low cost trace oxygen analyzer - Manual (Page 25)

Trace Oxygen Analyzer Operation 4
4-1 Teledyne Analytical Instruments
Operation
4.1 Introduction
Once the analyzer has been mounted, the gas lines connected and the
electrical connections made, the Analyzer can be configured for your appli-
cation. This involves setting the system parameters:
• Defining the user selectable analysis ranges.
• Setting alarm setpoints.
• Calibrating the instrument.
All of these functions are performed via the front panel controls, shown
in Figure 4-1.
Analyzing for the trace oxygen level in the gas passing through the cell
block is the default mode of operation. As long as no front panel buttons are
being pressed the Unit is analyzing.
Figure 4-1: Front Panel Controls and Indicators