Server FSAF (85070) - Manual (Page 3)

UNIT TAKE-DOWN
1 PRESS SWITCH TO “OFF” POSITION.
2 UNPLUG CORD.
Caution- Hot:
• If unit has already been in use, unit may
still be hot. Allow unit to cool before
continuing.
3 REMOVE LID FROM UNIT.
4 REMOVE RESERVE PRODUCT POUCH FROM UNIT
BY PULLING POUCH UP AND OUT OF UNIT.
5 REMOVE PUMP WITH PRIMARY PRODUCT POUCH
ATTACHED.
• Grasp both pump and pouch and pull them
together up and out of unit.
6 DISCONNECT PUMP FROM PRIMARY PRODUCT
POUCH.
• Pull pump connector out of circular pouch fitment.
1 2
1
2
UNIT SET-UP
UNIT TAKE DOWN
7 FLUSH AND RINSE ALL INSIDE AND OUTSIDE
SURFACES OF PUMP THOROUGHLY WITH HOT
WATER.
• Place lower end of pump into container of
hot water and operate pump until all (if any)
remaining product is expelled and only hot water
flows from discharge tube. Then remove pump
from container of water to disassemble.
8 DISASSEMBLE AND CLEAN PUMP.
SEE SEPARATE PUMP MANUAL.