Power Probe The Hook - Manual (Page 6)

Page 6
O R E V D P L D
5
S E C T H R
5 0
A
C T P W S W I H
E P U L S
O
.5 sec
.5 sec
.5 sec On_
Off
Press &
Release
START
Press &
Release
STOP
Press &
Release
ON
Press &
Release
OFF
C T P W S W I H
H L A T C
O
C T P W S W I H
N M OM E T
O
Press
ON
Release
OFF
On_
Off
On_
Off
d) power Switch preferences
To adjust and set the Power Switch Preferences
while in PPHM:
1. Press SEL once.
2. Press D once. Display shows POW SWITCH.
3. Press L or R to select the desired Power Switch preference:
LATCH, PULSE or MOMENT.
4. Press SEL to return to PPHM.
5. Notice the new Power Switch Setting in the preference line.
Power Switch Behaviors when in PPHM:
M= Moment: When the Power Switch Setting is set to M, bat-
tery source power or ground is supplied to the probe tip when
you press and hold U(+) or D(–).
L= Latch: When the Power Switch Settings are set to L you
can hold continuous battery positive or ground to the probe tip,
by pressing the U(+) or D(–). To release power, press U(+) or
D(–) again.
P= Pulse: When the Power Switch Setting is set to P, the PPH
will cycle battery positive or ground to the probe tip by pressing
U(+) or D(–).
It cycles ON for .5 seconds, then OFF for .5 seconds repeat-
edly. To stop the power cycling, press U(+) or D(–) again.
e) AC threshold preferences
To adjust and set the AC Threshold Preferences
while in PPHM:
1. Press SEL, once.
2. Press D, twice. Display shows AC THRES.
3. Press L, or R, to select the desired AC Threshold
preference: .1, .2, .5, 1, 2, 5, 10, 20, or 50.
4. Press SEL to return to PPHM.
5. Notice the new AC Threshold Setting in the preference line.
f) LED Voltage Drop preferences
To adjust and set the LED Voltage Drop Preferences
while in PPHM:
1. Press SEL once.
2. Press D, 3 times. Display shows LED V DROP.
3. Press R or L, to select the desired Voltage Drop preference:
.2, .5, 1, 2, or 3.
4. Press SEL to return to PPHM.
5. Notice the new LED Voltage Drop Setting in the
preference line.
III
Continued