Fill descaler press start, Calc‘n‘clean in progress, Place container pull milk frother – Bosch TES50251DE VeroCafe Kaffeevollautomat silber User Manual
Page 39: Clean / fill water tank press start, Push milk frother, Empty drip tray insert drip tray

35
TES502 | 02/2013
35
en
N.B.: If the water filter is activated, the
display will prompt you to remove the filter
and then press the
start button (10) again.
Remove the filter now if you have not
already done so.
Press the
start button (10).
Fill descaler
Press start
● Pour lukewarm water into the empty
water tank (16) up to the
0,5l mark and
dissolve 2 Bosch descaling tablets in it.
● Press the
start button (10).
Calc‘n‘Clean in progress
The descaling pro gramme will now run for
about 10 minutes.
Place container
Pull milk frother
● Place a receptacle with a capacity of at
least 1 litre under the outlet.
● Pull the milk frother (6) to open it.
Calc‘n‘Clean in progress
The descaling pro gramme will now run for
about 12 minutes.
Clean / Fill water tank
Press start
● Rinse the water tank (16) and refill it with
fresh water up to the
max mark.
● Press the
start button (10).
Calc‘n‘Clean in progress
The descaling pro gramme now runs for
about 30 seconds and rinses the appliance.
Push milk frother
● Push the milk frother (6) in to close it.
Calc‘n‘Clean in progress
The cleaning pro gramme will now run for
about 8 minutes.
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them.
Replace the filter if one is being used. The
appliance has finished cleaning is ready for
use again.
Important: Wipe down the appliance using
a soft, damp cloth to immediately remove
any descaler residue. Such residue can
cause corrosion. New sponge cloths may
contain salts. Salts can cause rust film
on stainless steel and must therefore be
washed out thoroughly before use.
TES502_1DE.indb 35
21.02.2013 13:21:48