Bosch TES50251DE VeroCafe Kaffeevollautomat silber - Manual (Page 30)

26
Robert Bosch Hausgeräte GmbH
26 en
Note: You can use the fi lter indicator to
mark the month in which you inserted the
fi lter. You can also mark the month in which
you will need to replace the fi lter next (at
the latest after two months).
Note: If the appliance has not been used
for a prolonged period (e.g. vacation) the
fi lter should be rinsed before the appliance
is used again. To do so, dispense a cup of
hot water and pour it away.
Menu settings
You can adapt the appliance to your indi­
vidual needs in the menu settings.
1. Hold the
e
off / j button (12) down for
at least 3 seconds.
2. Press the
e
off / j button (12) repeat­
edly until the required menu item
appears in the display.
3. Select the required setting with the
upper rotary knob (14).
4. Confi rm by pressing the start button
(10).
To leave the menu without making any
changes, turn the rotary selector to Exit
and press the start button (10).
You can set the following:
Shut off
Here you can set the time span after which
the appliance automatically switches off
following the last drink preparation. A time
between 15 minutes and 4 hours can be
set. The default time is 1 hour, but this can
be shortened to save energy.
Filter
Here you can set whether a water fi lter is
being used. If a water fi lter is not being
used, turn the setting to No / Old . If a
water fi lter is being used, turn the setting to
Activate fi lter . New water fi lters have to
be rinsed before use (see “Water fi lter” on
page 25).
Start Calc‘n‘Clean
The service programmes ( Calc‘n‘Clean /
descaling / cleaning ) can be selected
manually here. Press the start button (10)
and run the selected programme (see
“Service Programmes” on page 32).
Temp.
The brewing temperature ( high / middle /
low ) can be set here.
Language
The display language can be set here.
Water hardness
The water hardness setting can be adjusted
on this appliance. It is important to set the
water hardness correctly, so that the appli­
ance indicates accurately when the descal­
ing programme should be run. The factory
setting for the water hardness is 4.
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier.
Dip the test strip briefl y in water, gently
shake off any drips, and check the result
after one minute.
Level Water hardness
German (°dH) French (°fH)
1
2
3
4
1­7
8­14
15­21
22­30
1­13
14­25
26­38
39­54
TES502_1DE.indb 26 21.02.2013 13:21:42