Andrew 9.3-Meter ESA - Manual (Page 25)

Elevation
Jackscrew
Assembly
Step 1
Step 2
25
Installation Procedures
Figure 20
Refer to Figure 20. Apply supplied RTV to indicated flange surfaces and attach 200013-
3/200048 elevation jack screw to 200128 elevation extension assembly as shown.
•
Use 1-1/4 by 3-1/2 in (89 mm) bolts, washers and nuts
Note: Mounting hardware is included with corresponding jack assembly hardware kit.
Attach 200022 pivot assembly to enclosure tripod leg assembly Note: This may also be
performed during reflector assembly.
•
Use 3/4 by 3.0 in (75 mm) bolts, lockwashers and nuts.
APPLY RTV
APPLY RTV
APPLY RTV
3/4 x 3” LG.
(75 mm)