Bosch TES50159DE VeroCafe Kaffeevollautomat schwarz User Manual
Page 29
29
TES501.. 08/2011
en
Important: If a water ilter is used (special
accessory order no. 461732), proceed as
follows, see „Water ilter“ auf Seite 27.
Note: If no button is pressed within 90 sec
onds, the appliance switches to standby
mode without saving the new settings. In
this case, the previously saved water hard
ness setting is retained.
Automatic switch-off
Here you can set the period of time after
which the appliance should switch off au
tomatically following the last drink prepa
ration. A time between 15 minutes and 4
hours can be set. The default time is 1 hour,
but this can be shortened to save energy.
1. Turn the rotary
knob (13) to position
2. Press and hold buttons
B
(11) and
A
(12) simultaneously for at least 5 sec
onds. The time after which the appliance
should switch off is indicated by the
number of LEDs that now light up.
3. Now press the start button (10) repeat
edly until the required number of LEDs
light up to indicate the switchoff time:
D
= 15 minutes
D
and
E
= 30 minutes
D
,
E
and
F
= 45 minutes
D
,
E
,
F
and
G
= 1 hour
D
,
E
,
F
,
G
and
H
= 2 hours
D
,
E
,
F
,
G
,
H
and
I
= 4 hours
4. Press and hold the start button (10) for
at least 5 seconds. The set number of
LEDs will light up to indicate that the
selected switchoff time has been saved
successfully.
Note: If no button is pressed within 90 sec
onds, the appliance switches to standby
mode without saving the new settings. In
this case, the previously saved switchoff
time is retained.
Setting the brewing temperature
The brewing temperature can also be set.
1. Turn the rotary
knob (13) to position
2. Press and hold buttons
B
(11) and
A
(12) for at least 5 seconds. The set
brewing temperature is indicated by the
number of LEDs that now light up.
3. Now press the start button (10) repeat
edly until the required number of LEDs
light up to indicate the temperature:
LED
D
= low
LED
D
and
E
= medium
LED
D
,
E
,and
F
= high
4. Press and hold the start button (10) for
at least 5 seconds. The set number of
LEDs will light up to indicate that the
selected temperature has been saved
successfully.
Note: If no button is pressed within 90
seconds, the appliance switches to stand
by mode without saving the new settings.
In this case, the previously saved brewing
temperature setting is retained.
TES501_1DE.indb 29
05.08.2011 15:34:47