Apple Studio Display 17 (ADC) Monitor Stand Replacement - Manual (Page 5)

Apple Studio Display 17 (ADC) Monitor Stand - 5
8. With the tabs aligned, gently pull the stand toward you. Then tilt the
stand up off the base.
Positioning the Plastic Rings
After you remove the monitor stand, two plastic rings should remain on the
base. These rings are fitted in a special orientation so the replacement
stand will fit properly. However, if the rings are dislodged, replace them as
follows:
1. Place the white plastic ring on the base so that you can still read the
words "Serial Number" when the ring is slid all the way down. Turn the
ring over if the words are not visible
White Ring
Correctly Installed