Pach and Company AeGIS NPB9000 Series Manual User Manual

Page 40

FUNCTION CODE

LOCAL PROGRAMMING

DISPLAY SYSTEM INFORMATION

CLEAR THE EEPROM MEMORY

TO FACTORY DEFAULT

VIEW DIRECTORY AND NAME

Step 5

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function Code 46 then press # and the display shows

XXXX= a maximum number of tenants
YYYY= a maximum number of keypad access code and card.
MM.DD.YYYY= Month. Date. Year the Firmware is released.

Then the display shows

Step 3

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function Code 50 then press # and the display shows

Step 3

Enter 1=TO CLEAR or 0=TO CANCEL then press #, the display shows

Step 4

Wait for a few minutes, the more tenants programmed the longer it takes to
erase the memory the the display shows

Step 5

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function Code 78 then press # and the display shows

NNNNNNNNNNN= tenant name

Pach and Company

Chapter 3

Page 32

AeGIS NPB9000 Series

PROGRAMMING

05/01/02

SELECT PROGRAM
ENTER: _ _ PRESS #

V ER AXXXRYYYY
MM.DD.YYYY CR

SELECT PROGRAM
ENTER: _ _ PRESS #

0/1 CLR eeprom . . .
N/Y:0 # ENT * EX

INITIALIZATION . .
EEPROM Testing . .

Welcome to Pach’s Telep
Press 3 for Dir .

SELECT PROGRAM
ENTER: _ _ PRESS #

NNNNNNNNNNNN
Press # to view