Warning – Pach and Company AeGIS NPB9000P Series Manual User Manual

Page 35

FUNCTION CODE

LOCAL PROGRAMMING

MASTER CODE MASK

(Default setting is disabled)

WARNING !!!!!!!!

• Master Code cannot be recovered

if Master Code Mask is enabled. You

must request a new memory

(EEPROM) from Pach and Company

for nominal charge.

• The square RED button (retrieval

switch) on the board cannot recover

your existing master code.

OPEN DOOR BEEP

(Default setting is enabled)

• The system will beep if relay or

relay 1 (door 1) or relay 2 (door 2) is

unlocked.

ENABLE OR DISABLE PBX

(Default setting is disabled)

NOT APPLICABLE FOR NON

SUBSCRIBER (NPB 9000 SERIES)

Step 5

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function Code 40 then press # and the display shows

Step 3

Enter 0=NO or 1=YES then press # the display shows

Step 4

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function Code 41 then press # and the display shows

Step 3

Enter 0=NO or 1=YES then press # the display shows

Step 4

Select another Function Code to program different field from the table or
press * to exit the programming mode.

NOT APPLICABLE FOR NON SUBSCRIBER (NPB 9000 SERIES)

Pach and Company

Chapter 3

Page 27

AeGIS NPB9000P Series

PROGRAMMING

06/20/11

SELECT PROGRAM
ENTER: _ _ PRESS #

MC DISPLAY MASK
0=NO 1=YES : 0

SELECT PROGRAM
ENTER: _ _ PRESS #

Open Door Beep
0=NO 1=YES : 1

SELECT PROGRAM
ENTER: _ _ PRESS #