Pach and Company AeGIS NPB9000P Series Manual User Manual

Page 21

Pach and Company

Chapter 3

Page 13

AeGIS NPB9000P Series

PROGRAMMING

06/20/11

FUNCTION CODE

LOCAL PROGRAMMING

NOT APPLICABLE FOR NO PHONE BILL

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function Code 10 then press # and If relay 2 is set as a DOOR
CONTROL in Function Code 08 the display shows

If relay 2 is set other than a Door Control, proceed to step 4.

Step 3

Enter 1 for relay 1 (door 1) or 2 for relay 2 (door 2) then press #, the display
shows

Step 4

Enter 01-98 (unlock 1-98 hours) or 99 (unlock hold) then press #, the
display shows

Step 5

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function Code 11 then press # and the display shows

ALARM TELEPHONE NUMBER

NOT APPLICABLE FOR NON

SUBSCRIBER

MANUAL UNLOCK/LOCK OR

UNLOCK HOLD DOORS TIMER

Set the timer to unlock/lock or unlock

hold relay 1(door 1) or relay2 (door

2).

01-98 hours - doors will unlock and

lock for 01 - 98 hours.

99 - doors will unlock for indefinite

time (unlock hold).

EDIT WELCOME MESSAGE

DISPLAY

The welcome screen is a scrolling
display. A total 48-characters (16 -

characters for each segment) can be

programmed for the welcome

message.

SELECT PROGRAM
ENTER: _ _ PRESS #

Set Which relay
(1 or 2): _

HOURS UNLOCK
ENTER: _ _ PRESS #

SELECT PROGRAM
ENTER: _ _ PRESS #

Welcome to Pach’
MESSAGE SEGMENT 1