Nova-Tech CPWplus - Manual (Page 9)

© Adam Equipment Company 2008 7
3.3 SETTING UP
3.3.1 SETTING UP THE STANDARD CPWplus plus plus plus SERIES
1 Remove the parts from the packing
carefully. Place the base on a rigid surface.
Place the Stainless Steel pan on the base, if
it not already assembled.
2 The indicator is separately packed and
comes attached to a bracket with the help of
two thumb screws.
To adjust the angle of the indicator, use the
two thumb screws on the side of the bracket
that connects the indicator.
3 Connect the cable attached to the base
to the connector at the rear of the indicator.
Tighten the ferrule to secure the cable.
NOTE: When moving the scale, take care to
prevent bending of the cable and connector
too much as over a period of time this can
weaken the wires in the connector and
cause malfunction.
4 Power can be supplied using the adapter
delivering 12 VAC 150 mA minimum or using
batteries inside the scale unit (6 x AA size).
Remove
the cover from the battery
compartment under the scale. Install six AA
size batteries as shown below.
The alkaline batteries are suggested for use
for best life.
MOUNTING THE INDICATOR- The indicator attached to the bracket can be mounted in the
following 3 ways. To adjust the angle of the indicator, use the two thumb screws on the side of the
bracket that connects the indicator.
1. Place it on the work bench- Simply place the indicator attached to the bracket on the work
bench at an angle.
2. Attach it to the base of the scale- There are two thumb screws on the base (opposite to the
Power input and RS-232 ports). Remove them from the base and use them to attach the bracket
to the base.
3. Mount it on the wall- Use two suitable screws (not supplied) to fix the bracket to the wall.
Thumb Screw
Bracket
6 X "AA" Alkaline
Ferrule
Connector
on the
Indicator
Connector
attached to
the cable