Nova-Tech B4000-M - Manual (Page 9)

1 3 6
6. Operation
6.1 Getting Started
6.1.1 Open the chamber door and remove all inner packing and
accessories.
6.1.2 Plug the power cord into the proper electrical outlet. (Please
check that the power source is in accordance to the electrical
specifications of the machine (listed on the power label).
6.1.3 Power on - The switch is located underneath the control panel
on the front side of the machine.
6.2 Filling the water tank
Open the top lid, and fill the tank with water. The water should
be filled within approximately 1 inch of the black seal. If you hear a beep
signal, the max water level is exceeded. Please stop filling immediately.
distilled
Following power up, the control panel illuminates.
The Time window will display Ld .
6.3 Sample Preperation
For the most effective sterilization and to preserve the sample, please
follow below:
* Arrange the samples of different material on different trays or with at least
2in. of space between them.
* Always insert a sterilization paper or cloth between the tray and sample,
to avoid direct contact between the different materials.
Instructions manual Instructions manual
8.6 Replacing the power fuse
1). Switch off the power.
2). Push inward with a flat head
screw driver, then unscrew the fuse
counter clockwise). holder (
3). Pull out the fuse holder by
hand.
4).Replace the fuse with a fuse
of the proper electrical
requirements (see pg.2).
.
5). Place the fuse holder back in
place and use a flat head screw
driver to fully push it in. Then
tighten (clockwise).
9.1 Switch off the sterilizer before transportation or storage. Pull out the plug
and let the machine cool down.
9.2 Drain both the clean and the used water tank.
9.3 Conditions for transportation and storage:
Temperature: -20 C /~ +55C
Relative humidity: 85%
Atmospheric pressure: 50kPa~106kPa
9 Transport and Storage