Nova-Tech B4000-M - Manual (Page 7)

1 5 4
4. Installation
*
*
*
*
*
Ensure that the sterilizer is installed with 2.5in. (10cm) ventilation space
on all sides of the sterilizer, and 5 in. (20cm) on top side. The clearance
required to open the door is 15.5in. (40cm).
The sterilizer should be placed on a level worktable.
Do not cover or block the door, ventilation or radiation openings on the
sterilizer.
Do not install the sterilizer near a sink or in a location where it is likely to
be splashed.
Do not install the sterilizer nearby a heat source.
Instructions manual Instructions manual
For additional information on any of the error codes listed in section
10, please contact your sales representative, or contact Biomega
Research Products Service Department at 1-908-769-5555. Please
have the unit’s serial number (located on the back panel of the
instrument) available when calling. Do not send in a unit for service
without first calling to obtain a repair authorization number and a
decontamination form. The unit should be properly packed to avoid
damage. Any damage resulting from improper packing shall be the
responsibility of the user.
11. Service and contact
(Above dimensions are shown in mm.)