Diamond Products FZ-2ST - Manual (Page 30)

6.4 End of machining
•
Turn off power unit and unplug mains
•
Relieve pressure from the hydraulic circuits
•
Clean wall saw system, e.g. by hosing it
down
•
Remove blade guard
•
Remove saw blade and keep screws sa-
fely or screw them back into holes
•
Disconnect hoses
– Turn the locking ring
– Hold the hose end in straight position
– Push the coupling sleeve back
– Remove the hose
– Connect both ends of the hose package
in order to keep the couplings clean and
protect them from damage during trans-
port
•
Unscrew the guide grips completely
•
Remove the wall saw head
•
Remove the tracks
Thvt Aa!T
Page 30 FZ_29811