Diamond Products FZ-2ST - Manual (Page 22)

5.5 Changing the saw motor
Removing the saw motor
Never connect or disconnect
hoses when the unit is running.
•
Turn off power unit
•
Turn the pressure control to zero
•
Disconnect the hoses from the saw motor
– Turn the locking ring
– Hold the hose end in straight position
– Push back the coupling sleeve
– Remove the hose
Always keep the hose couplings clean.
Leave the hose connected to the unit so
that pressure could be relieved via the
unit.
•
Remove the allen head screws.
•
Turn the saw motor and remove it.
Mounting the saw motor (Size 2)
•
Put the saw motor straight on to the drive
shaft and turn it
•
Tighten the screws (M8)
Mounting the saw motor (Size 3)
•
Remove the double thoothed profile clutch
•
Put the saw motor straight on to the driving
shaft and turn it
•
Tighten the screws (M10)
Connecting the hoses
•
Push the hose coupling on or into its coun-
terpart until you hear it "click"
•
Turn the locking ring of the coupling into its
secured position
Always make sure that the hoses are pro-
perly connected. Always secure them by
turning the locking ring.
6yyrÃurhqÆp rÃH'‘!$
! ThГ€‚‡‚ Г†v“rÃ!
" 9‚ˆiyrǂ‚‡urqà ‚svyrÃpyˆ‡pu
# 9 v‰rÆuhs‡
$ 6yyrÃurhqÆp rÃH ‘!
% ThГ€‚‡‚ Г†v“rÃ"
Fig. montmot.tif
Tr‡ˆƒ Aa!T
Page 22 FZ_29811