Diamond Products FZ-2ST - Manual (Page 26)

•
Fasten the saw blade with saw blade cover
and central lockscrew M16x30, or with saw
blade cover and six screws M8x16
V†ry’Çur†rÆp r†)ГH'‘ %Г„ˆhyv‡’Г !(Г9DIГ( !
P qr ГI‚Г D ' %
•
Check the blade angle and readjust track
bases
•
Mount the blade guard
Mounting saw blade and flush cutting flange
ThÃiyhqr
! Ayˆ†uÃpˆ‡‡vtÃsyhtr
" 6yyrÃurhqÃp‚ˆ‡r †ˆxÆp r†ÃH'Y %à (
# 6yyrÃurhqÆp r†ГH'‘ %Г !(
$ 7yhqrÃuˆi
% Ayh‡Ãƒhpxvt
•
Fasten flush cutting flange with six screws
V†ry’Çur†rÆp r†)ГH'‘ %Г„ˆhyv‡’Г !(Г9DIГ( !Г
P qr Г‚Г D ' %
•
Fasten the saw blade with six screws
V†ry’Çur†rÆp r†)ГH'‘ %Г„ˆhyv‡’Г (Г9DIГ&(( Ã
P qr Г‚Г D#' %!
•
Check the blade angle and readjust track
bases
Ayˆ†uÃpˆ‡‡vtГv†Г‚y’††viyrÐv‡uÇurǐ‚ƒvrprÃiyhqrÃtˆh qÃ
hyˆ€vˆ€
•
Remove the cover plate from the blade
guard
After flush cutting
•
Remount the cover plate to the blade
guard.
5.11 Connecting the power unit
Fundamentals
Never connect or disconnect
hoses when the unit is running.
•
Connect couplings with elbow pieces to the
wall saw system
•
Connect straight couplings to the power
unit
•
Keep the couplings clean
Connect both ends of the hose packa-
ge. Thus the hose couplings are kept
clean and will not be damaged during
transport.
If the hoses can not be connected easily they
are under pressure (see below).
Relieving pressure in the hose
1 At the power unit: Actuate the main
circuit valve or the spool valve se-
veral times
2 At the hose: Put the supplied pressu-
re relief valve on the coupling and
srew it in
Fig. fz4-6.tif
Tr‡ˆƒ Aa!T
Page 26 FZ_29811