Diamond Products FZ-2ST - Manual (Page 3)

0.5 Table of contents
0.1 Introduction 2
0.2 Validity of this manual 2
0.3 Technical standards 2
0.4 Delimitation of system 2
0.5 Table of contents 3
1 Safety instructions 4
1.1 Fundamentals 4
1.2 Before machining 7
1.3 During sawing 8
1.4 After machining 8
2 Technical data 9
2.1 Dimensions (Text) 9
2.2 Dimensions (Figure) 9
3 Range of application 10
3.1 Connectable units 10
3.2 Possible applications 10
4 Design and function 11
4.1 Design of wall saw system 11
4.2 Safety devices 11
4.3 Track system 11
4.4 Design wall saw head 11
4.5 Function 12
4.6 Operating elements and connections 14
5 Set-up 16
5.1 Initial set-up 16
5.2 Preparatory operations 16
5.3 Choosing the saw blade 17
5.4 Choosing the saw motor 20
5.5 Changing the saw motor 22
5.6 Fixing the tracks on concrete 23
5.7 Mounting the wall saw head 24
5.8 Fasten the adjusting grips 24
5.9 Release of the carriage guides 25
5.10 Mounting blade and blade guard or flush
cutting flange 25
5.11 Connecting the power unit 26
6 Sawing 28
6.1 Before sawing 28
6.2 The first cut 28
6.3 After the first cut 29
6.4 End of machining 30
7 Troubleshooting 31
8 Maintenance 33
8.1 Maintenance table 33
8.2 Change oil swivelling arm 34
8.3 Replacing guiding devices 35
8.4 Replacing feed motor 35
8.5 Replace swivelling motor 35
8.6 Refilling lubricant 36
9 Repairing 37
10 Transport, placing out of service,
storing, disposal
38
10.1 Transport 38
10.2 Placing out of service and storage 38
10.3 Disposal 38
11 Accessories 39
12 Spare parts list 40
12.1 Order indications 40
12.2 Table of contents (Spare parts) 41
Aa!T
FZ_29811 Page 3