MIDLAND BT City - Manual (Page 21)

UK
5
Switching your Midland BTCity/BTEva
on and off
Switching the unit on:
› Press and hold “Control” button down for approximately 3 seconds
until the BLUE indicator lights.
Switching the unit off:
› Press and hold both “Control” and “VOL-” buttons together for ap-
proximately 3 seconds until the RED indicator flashes 3 times, thus
lessening the chances that you might turn off the unit accidentally
(especially whilst wearing heavy gloves).
Adjusting the volume
Your Midland BTCity/BTEva uses AGC technology, which automatically
adjusts the listening volume in relation to background noises.
However, it is also possible to manually adjust the volume by means
of the “Volume+” and “Volume -“buttons.
Attention: volume can be adjust only when an audio connection
is active.
Pairing with Bluetooth devices
Your Midland BTCity/BTEva is a Bluetooth unit that can be paired with
other Bluetooth devices, such as a mobile phone or another BTCity/
BTEva device for Intercom communications.
Before performing this procedure, it is necessary to set BTCity/BTEva
into the Setup mode.
Setup mode
› Switch off the BTCity/BTEva device. Press and hold down the
central button “Control” for about 7 sec. until the red indicator
switches on permanently. BTCity/BTEva is now in “Setup” mode
and can therefore be paired with other devices.
Exiting from the Setup mode
› To exit the Setup mode double click the “Control” button. Once the
red light turns off, the blue led starts blinking. Now you can use
your BTCity/BTEva.
Using the features of the Bluetooth
devices
Using the telephone feature
To use the Telephone feature, be sure the units are correctly paired
together.
Pairing the unit with a mobile phone
1. Enable the Bluetooth device search feature on your mobile phone.
As this procedure varies according to the brand and model of the
mobile phone, refer to the manual supplied to your particular pho-
ne for further information.
2. Set the BTCity/BTEva unit in “Setup” mode, then press the Control
button on the unit until the red and blue indicators start flashing.
3. After a few seconds the mobile phone will display “Midland BTCi-
ty/BTEva”. Select it and follow the instructions provided in your
mobile phone manual to accept the pairing. When prompted,
enter the pairing code, which is 0000 (four zeroes). Your mobile
phone should then display a confirmation message if the pairing
operation has been successfully completed
4. The BTCity/BTEva will automatically exit the set up mode (red indi-
cator on) and go to the working mode (blue light flashing).
Answering a call
When you hear the phone ring, you can answer in two different ways:
Vocally:
Simply say one word to answer the call and start talking.
Remembering that you can only do this if you answer the call
after the third Ring. (Be aware that some phones may not
support voice answering)
Manually:
Tap the “Control” button and start speaking.