Mobi Technologies 70120 DualScan ULTRA User Manual

Page 13

MAINTENANCE, STORAGE AND CALIBRATION

CARE AND CLEANING

Maintenance:
1. Remove all stains from the device with a soft, dry cloth.
2. Clean the tip of the probe as follows: Wipe the surface gently with a swab

of cotton or a soft cloth moistened with alcohol until no dirt or wax remains.

Allow the alchol to dry before using thermometer again.
3. Do not wash the thermometer with water, abrasive detergent or detergent

containing benzene or other harsh solvents.
Storage:
1. After each use, clean the thermometer and put on the protective cover.
2. Do not leave the thermometer exposed to direct sun, high temperatures,

3. If you plan to not use the thermometer an extended time, remove the

batteries.
Calibration:
The thermometer is factory-calibrated. If it is used according to this user

manual, periodic recalibration is not required. If there are doubts concerning

the accuracy of the thermometer, please contact Mobi at the address

given herein. Do not try to repair or modify the thermometer yourself.

1. Keep the probe surface clean, otherwise the measurement may not be

accurate.
2. Clean the probe with a non-abrasive cloth or paper moistened with water

or alcohol, and conduct measurement after the water or alcohol on the

surface of the probe has evaporated.

Caution:

Make sure the probe tip of the thermometer is completely clean. A dirty

probe lens will cause inaccurate measurements.