American Standard Plumbing Product User Manual

Countertop sink, Installation instructions, Recommended tools & materials

730864-100

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

NOTE:

Pictures may not exactly define contour of china and components.

INSTALLATION
INSTRUCTIONS

Countertop Sink

Introduction: Thank you for selecting our products...products which have been the benchmarks of
fine quality for years. To help insure that the installation process will proceed smoothly, please read
these instructions carefully before you begin. Also, review the recommended tools and materials list;
carefully unpack and examine your new plumbing fixture.

Adjustable Wrench

Channel Lock Pliers

Regular Screwdriver

Recommended Tools & Materials

Phillips Screwdriver

Pipe Wrench

Putty Knife

Drill

Saber Saw

Basin Wrench

Plumbers' Putty
or Caulking

Tubing Cutter

Tape
Measure

Hacksaw

Using the template provided, locate the position of the sink. Provide proper clearance under the countertop for the faucet supply
lines, drain assembly and the structural parts of the cabinet.

NOTE: If replacing an existing sink be certain to shut off water supply before removing old sink.

Perimeter
of template

Drill a clearance hole
inside the perimeter line
of the template.

Cut opening around the
perimeter of the
template.

Mount the faucet and drain assembly (not included) on
the sink following faucet manufacturer's instructions. Be
certain to apply a bead of sealing putty on the underside
of the drain (Part "A") in order to ensure a watertight seal
between the sink and drain. Remove excess putty after
installing drain on sink.

Before applying the sealant, place the sink temporarily into
the cut-out. Check for alignment and clearance. Then
mark the sink

and countertop in several places as a guide

for the installation location.

After checking fit and alignment, turn sink upside down
and apply a generous portion of sealant around the
underside of the rim near the edge. Carefully lower sink in
place, align with marks made earlier, and press down
firmly. Allow sealant to set before connecting supplies
and drain.