Meriam MFC5150 HART Communicator Manual User Manual
Page 43
37
SAFETY NOTICES
Waste Electrical and Electronic Equipment (WEEE), Directive 2002/96/EC
(This directive is only valid in the EU.)
This product complies with the WEEE Directive (2002/96/EC) marking requirement.
The following marking indicates that you must not discard this electrical/electronic product in domestic
household waste.
Product Category
With reference to the equipment types in the WEEE directive Annex 1, this product is classified as a “Monitoring
and Control instrumentation” product.
Do not dispose of in domestic household waste.
When disposing of products in the EU, contact your local Meriam representative.
SPARE PARTS LIST
ZA900529-00014 HART Test Lead Kit (included w/ unit) - standard banana plugs, mini-grabbers,
250 Ω shunt resistor
ZA36821
Std size 250 Ω shunt resistor (incl’d w/ unit) - req'd for HART low resistance loops
Z9P790
Soft carrying case (included w/ unit) - custom soft case with adjustable shoulder strap
and HART lead compartment
Z9P791
Hand strap (included w/ unit)
Z9A820-2
5150 Series Lithium Ion Battery Pack (included w/ unit).
Z9A879
5150 Series battery charger kit (included w/ unit), 100 – 240 Vac, 50/60 Hz Includes
recharging cradle, power cord and USB cable.
Z9P802
USB cable, Type A to B, 6.60 ft length (incl’d w/ unit); required for updates
Z9P822
5150 Series battery charger power cord (included w/ unit)
Z9P823
7/64” Hex key wrench (included w/ unit). Fits the battery pack screws.
Z9P780
5150 Series µSD system memory card (included w/ unit). 5150 software installed.
If an electric shock is felt when touching the charger or YHC5150X docked in the charger,
unplug charger immediately from outlet. Remove the YHC5150X from the charger
immediately after you determine it is safe.
If there is any deformation, cracks or other damage to the charger base, power cord, or power
adapter, unplug the charger and discontinue use.
Do not disassemble or modify any component. This could cause failure or injury, invalidate
certification and void the warranty.
Plug power adapter directly into an outlet. Do not use power adapter with an extension
cord.
Do not subject the batteries to intense heat. This could cause overheating, fire, rupture or explosion.