MaxPower Corp GE SG Series 10-150kVA - Manual (Page 10)

Factory Testing can include, but is not limited to:
• Functional test of full parallel RPA system including transfers
to bypass, utility failure, EPO etc.
• Full Functional test of parallel RPA system including master
fail and communications failure simulations
• Steady state measurements from 0-100% load of voltage,
current, output voltage regulation, input/output power
factor, output voltage THD, input current THD, frequency.
• Overload of full system up to 150%
• 100% utility failure with waveform capture
Factory Testing and Customer Witness Testing
• 0-100% step loads with waveform capture
• 0-100% bypass transfers with waveform captures
• Output short circuit with waveform capture
• Removal of module from the system with waveform capture
• Inverter or power supply failure simulations
• Full functional test of RPA output switchgear including
transfers in and out of main bypass mode
Field Testing & Service Capabilities
On-Site Services that include:
•
UPS Module Startup & Test
• Battery Measurement & Monitoring
• Load Bank Testing
• Thermography Testing
• Project Management
• Site Commissioning Assistance
• Repair, upgrade, retrofit
• Site Audits & Assessments