Allied Telesis AR300 series - Manual (Page 25)

Software Release 2.3.1 25
Software Release 2.3.1
C613-10325-00 REV B
To re-enable HTTP cookie requests to pass through the HTTP proxy, use the
command:
ENABLE FIREWALL POLICY=name HTTPCOOKIES
For example, to enable the passing of HTTP cookies through HTTP proxies
configured for the policy zone1, use the command:
ENABLE FIREWALL POLICY=zone1 HTTPCOOKIES
Firewall Policy Debugging
By default, firewall policy debugging is disabled. To enable or disable it, use
the commands:
ENABLE FIREWALL POLICY=name [DEBUG={ALL|HTTP|PACKET|PKT|
PROCESS|PROXY|SMTP}]
DISABLE FIREWALL POLICY=name [DEBUG={ALL|HTTP|PACKET|PKT|
PROCESS|PROXY|SMTP}
The DEBUG parameter specifies the types of debugging information to be
enabled. If ALL is specified, all debugging information is enabled. If HTTP is
specified the display of information about request and response messages
passing through the HTTP proxy is enabled. If PROXY is specified the display
of general information about firewall proxies is enabled. The DEBUG
parameter is not retained over a reboot.
SHOW FIREWALL POLICY
The output for the SHOW FIREWALL POLICY [COUNTER] commands
include new parameters.
Table 5: New parameters in the output of the SHOW FIREWALL POLICY command.
Parameter Meaning
HTTP Proxy Filter File Name of a text file containing a list of domain names,
keywords and cookie options that are not allowed to pass
through HTTP proxies configured under this policy. This
parameter is only shown if a URL filter file has been
specified for this policy.
Cookies Indicates whether or not cookies are allowed to pass
through HTTP proxies configured under this policy. If
“enabled” is shown all cookies are permitted unless
specifically denied by an entry in the HTTP proxy filter file. If
“disabled” is shown no cookies are permitted. This
parameter is only shown if an HTTP proxy has been
configured for this policy with direction set to “out” or
“both”.