Magnum Venus Plastech Pro Gun CPD_PRTM - 1:1 - Manual (Page 31)

1:1 Classic Pro Gun Manual
Rev. 05/2012 Page | 31
4. Insert the actuating piston (5106-7-1) into the cylinder body (58631-1).
Note: Install the actuating piston into the cylinder so that the bushing is on the
high side of the piston centerline. Use caution not to damage the o-ring on the
piston while installing it into the cylinder body.
5.
Install new an o-ring (O-V-020) on each of the cylinder caps.
6. Reinstall the two cylinder caps on to the cylinder body.
7. Place new o-rings (O-V-013) in the grooves on the underside of the cylinder
body.
O-V-020 (O-RING)
O-V-013 (O-RING)
(O-RING)
(END CAP) 58631-1 (CYLINDER)
5106-5-1 (BUSHING)
5106-7-1 (PISTON)
5106-4-1 (END CAP)
5106-2-1 (ACTUATOR SEAL)