Magnum Venus Plastech CB-6000-RGT MATERIAL MONITOR - Manual (Page 17)

CB-6000-RGT Material Monitor Manual
Rev. 10/2012 Page | 17
Note: Pressing the will exit the programming process with out saving.
4. Press the button this will display . The display will automatically
switch between the setting and
5. With the display showing press the or until is
displayed. Six times for F1 and four times for F2.
6. Press the button once, then press the or until is
displayed.
7. Now press the button six times until is displayed again. The
display will automatically switch between the set point number and .
Use the button to select the column and use the and to enter
the desired Set Point number.
8. To save the changes press the until is displayed.
QUICK REFERENCE:
Press 6 times
Use the to select the numeric column and the and to change its value.
Enter the desired Set Point number then press through the remaining parameters
unit the display reads .
Note: Pressing the will exit the programming process without saving.
SP - 1
00000.0
PAR
PAR
Pro
Pro F1 F2 6 - SPt
PAR F1 F2 SP - 1
SP - 1
RST F1 F2
PAR
PAR
END
END
Pro
DSP
Pro
F1
6 - SPt
SPSEL SP - 1 SP - 1
Press 6 times
PAR F1 PAR
RST F1 F2
PAR
DSP