Magnum Venus Plastech Powerhead UPPH-10000 - Manual (Page 23)

UPPH–10000 Powerhead Manual
Rev. 05/2012 Page | 23
Air Cylinder Reassembly:
1. Install the Piston Rod Bushing (VPH-10011) into the Lower End Cap and secure with
the Snap Ring.
2. Place the Cylinder Piston (VPH-10003) onto the Lower End Cap o-ring (O-B-178).
3. Slide the Piston rod (UPPH-10009) and the Piston (VPH-10006) down into the
Cylinder (VPH-10003).
CAUTION: Use care not the scratch the inside of the Cylinder during installation.
4. Install the Lower End Cap (UPPH-10004) onto the Piston Rod (UPPH-10009) and
down onto the Cylinder (VPH-10003) with the valve block flats facing the same
direction.
5. Screw the hex nuts (F-HN-06F) onto the tie rods and snug the hex nuts.
6. Position the O-rings on the back of the Pilot Valve assembly
7. Mount the Pilot Valve assembly onto the side of the Powerhead using the four Cap
Screws (F-CS-04C-40). Be sure the Pilot Valve is positioned correctly.
8. Install the Muffler onto the Pilot Valve using the two Hex Bolts (F-HB-04C-56).
9. Using a drop of removable thread lock compound and
Install the Ball Joint (B-BJRE-
.750-1-HS) on the end of the Piston rod (UPPH-10009).
10. Mount the Power Head back onto the unit using the Shoulder Bolts (F-SB-12-32).
11. Connect the pilot air hose, regulated air hose and any Valves to Power Head.