beautypg.com

Magnum Venus Plastech Powerhead UPPH-10000 User Manual

Page 19

background image

UPPH–10000 Powerhead Manual

Rev. 05/2012

Page | 19

5. Insert the diaphragms (MPH-5010) into the upper and lower valve blocks with the

outside leading edge of the diaphragms facing out. Push the diaphragms all the way
down into the valve block bore. Install the valve exhausts (MPH-5009) onto the
upper and lower valve blocks. One side of the valve exhausts has three holes, one
of the holes must line up with the machined holes in the upper and lower valve
block. (See Figure 4)


6. Install the two socket head cap screws (FCS- 04C-08-SS) into each of the two valve

exhausts and snug tight.

Figure 4

Do not block the hole in the valve

block when installing the valve exhaust.


7. Install valve end caps (MPH-2521) into the upper and lower valve blocks and lightly

snug tight.
















Do not block hole