Magnum Venus Plastech Powerhead UPPH-10000 - Manual (Page 20)

UPPH–10000 Powerhead Manual
Rev. 05/2012 Page | 20
Air Cylinder Disassembly:
1. Remove the Shoulder Bolt (F-SB-12-32) from the Clevis (UPPH-10039) and Ball
Joint (B-BJRE-.750-1-HS). For easy repair the Power Head can be removed from
the unit and mounted in a vise by the Clevis on the Upper End Plate (UPPH-10012).
2. Remove the Ball Joint (B-BJRE-.750-1-HS) from the end of the Piston rod (UPPH-
10009)
3. Remove the five (5) Hex nuts (F-HN-06F) from the Tie rods (VPH-5003). Pull the Lower
End Cap (UPPH-10004) off the Cylinder (VPH-10003) and Piston Rod.
4. Slide the Piston rod (UPPH-10009) and Piston (VPH-10006) out of the Cylinder (VPH-
10003).
5. Use a pair of Snap Ring pliers to remove the Snap Ring (7205-2-26) from the Piston Rod
Bushing (VPH-10011)
6. Remove the Piston Rod Bushing (VPH-10011) from the Lower End Cap.
7. Replace all O-rings and coat with lithium grease (8465). Coat the inside of the
Cylinder, Piston rod and Piston rod bushing with lithium grease (8465).