beautypg.com

Air cylinder disassembly – Magnum Venus Plastech Powerhead VPH-10000 User Manual

Page 20

background image

VPH–10000 Powerhead Manual

Rev. 05/2012

Page | 20

Air Cylinder Disassembly:



1. Remove the Quick Pin (7203-8-1) from the Piston Rod (VPH-10008). Lift the

Connector Retainer (VPH-10010) up and remove the two Rod Connectors (VPH-
10009).

2. Remove the five (5) Hex nuts (F-HN-06F) from the Tie Rods (VPH-5003).

3. Pull the Upper End Cap (VPH-10002) off the Cylinder (VPH-10003).

4. Carefully lift the Cylinder (VHP-10003) off the Piston and Piston O-ring.

5. Slide the Piston Rod (VPH-10008) up from the Lower End Cap (VPH-10002).

6. Use a pair of Snap Ring Pliers to remove the Snap Ring (7205-2-26) from the Piston Rod

Bushing (VPH-10011).


7. Remove the Piston Rod Bushing from the Lower End Cap

8. Replace all O-rings and coat with lithium grease (8465). Coat the inside of the

Cylinder, Piston rod and Piston rod bushing with lithium grease (8465).